Flattening & Cutting Sheet Metal
Flattening & Cutting of Coils
Flattening and Cutting of Coils
Our expert team at C.S.M. Lo Cascio of Caltanissetta were the first to use the coil flattening and cutting system used. This advancement has helped expand the our already vast range of processing and producing of steel products.
As a result, we can offer you a wide choice of sheet metal - with production both in widths and thicknesses. Thanks to the use of our new production lines, it is possible to slip and cut coils having minimum widths of mm. 250 and maximum of mm. 2,000, with thicknesses between 0.5 and 8 mm.
As a result, we can offer you a wide choice of sheet metal - with production both in widths and thicknesses. Thanks to the use of our new production lines, it is possible to slip and cut coils having minimum widths of mm. 250 and maximum of mm. 2,000, with thicknesses between 0.5 and 8 mm.
In addition, the new sheet metal centre can rely not only on the site located in the new factories, but also on a commercial organisation supported by its own distribution structure.
The cutting line
Longitudinal Cuts
- Materials with Rm - less than or equal to -700N mmq.
Minimum width 70 mm.
Thickness: min. 0,5 mm.-max 3 mm. - Materials with Rm - less than or equal to -430N mmq.
Minimum width 750 mm.
Thickness: min. 3 mm.-max 8 mm.
Cross Cuts
- Materials with Rm - less than or equal to -700N mmq.
Minimum width 250 mm.
Thickness: min. 0,5 mm.-max 3 mm. - Materials with Rm - less than or equal to -430N mmq.
Minimum width 1,000 mm.
Thickness: min. 3 mm -max 8 mm.
Address
Via Dell'Imprenditore, 1Caltanissetta (CL) - Sicilia93100
Contact
+39 0934 21993comm@locascio.it
VAT Reg No. 01902500857
VAT Reg No. 01902500857
Designed by 
|
Questa azienda è presente anche su 
e 
|
Questa azienda è presente anche su
e